Grafana receiving data - but INDOOR sensor not on map

FAQ
1

My 3rd sensor - first 2 are working well! What am I doing wrong please?

EDIT - I had not ticked ‘Show Indoor Sensors’ on the map - Duh! “Issue” fixed…

Just built my 3rd sensor (first 2 working well) - I can see the data from the new sensor reliably charted in Grafana.

image
image1582×371 57.9 KB

I have registered the device ID on the community - but cannot see the blob on the map.
Device ID esp8266-12875293
Sensor IDs 90501 90502

When I click ‘show on map’ - the map open at the right place - but no blob.

image
image1195×734 31.8 KB

Any idea what to look for? Waiting for my facepalm of something obvious I have overlooked in the simple instructions!!

Huge thanks in advance…

2

Replying to self…

I had it marked as an Indoor Sensor - but the map was not set to show indoor sensors. Duh…
I’ll leave this here - hopefully useful to someone in the future.

3

Hello,
if you click on the button labeled with “PM 2.5 (5 min. mean)” then you can enable the indoor sensors.

4

Thank you - I eventually worked it out - but will leave the thread here for any future idiots like me!! :wink: