# nodeMCU and BME280 sensor

**URL:** <https://forum.sensor.community/t/nodemcu-and-bme280-sensor/2320>\
**Category:** FAQ\
**Created:** [September 26, 2023, 12:10pm UTC](https://forum.sensor.community/t/nodemcu-and-bme280-sensor/2320 "2023-09-26T12:10:05Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![c-mania](https://forum.sensor.community/letter_avatar_proxy/v4/letter/c/46a35a/32.png) [@c-mania](https://forum.sensor.community/u/c-mania)\
**Post date:** [September 26, 2023, 12:10pm UTC](https://forum.sensor.community/t/nodemcu-and-bme280-sensor/2320/1 "2023-09-26T12:10:05Z")

</div>

hello,

I have left a nodeMCU v0.9 - is it possible together with the BME280 sensor and is there a software for that.

many thanks, Peter

---

<div class="post-metadata">

**Author:** ![pjg](https://forum.sensor.community/user_avatar/forum.sensor.community/pjg/32/194_2.png) [@pjg](https://forum.sensor.community/u/pjg)\
**Post date:** [September 27, 2023, 5:37pm UTC](https://forum.sensor.community/t/nodemcu-and-bme280-sensor/2320/2 "2023-09-27T17:37:17Z")

</div>

Welcome!

> **[ESP8266 with BME280 using Arduino IDE (Pressure, Temperature, Humidity) |...](https://randomnerdtutorials.com/esp8266-bme280-arduino-ide/)**
>
> Learn how to use the BME280 sensor module with ESP8266 to read pressure, temperature, humidity and estimate altitude using Arduino IDE. It uses I2C or SPI communication protocol.

Should work but you have to check the pin out.  
Do you use Arduino IDE or Platformio?  
I think I also succeeded to flah the SC firmware on a NodeMCU 0.9.